Air Compressor Technical Center
In-depth knowledge base: maintenance manuals, diagnostic troubleshooting, and factory energy efficiency solutions.
Need technical support?
Our engineers are always ready.
Instructions on how to connect electrical wires to Hitachi air compressor
Kaeser is a famous air compressor belonging to KAESER company founded in 1919, in Corbug, Germany with more than 100 years of experience and present in almost all countries.
Principles for starting Kaeser air compressors
Direct contact with a power source can cause serious injury and even death: - Isolate all mains power sources (turn off the main isolator). - Make sure the power source does not turn on by itself. - Check that there is no residual voltage.
Safety devices and warning devices
Failure to comply with the following precautions may cause serious injuries. This machine is manufactured according to the most advanced and safety standards and regulations. However, potential risks such as injury or death when used and damage to the machine and other assets may occur during use.
Operating status and control mode of Kaeser air compressor
Operating Status There are 4 operating statuses. LOAD: Inlet valve is open. The compressor supplies compressed air to the entire system. Drive motor runs under full load.IDLING:Inlet valve closed. The minimum pressure/check valve separates the oil from the air system.
Ingersoll Rand air compressor spare parts
During operation and operation of Kaeser air compressors, it can cause injuries, fires and explosions to humans. Therefore, it is necessary to pay close attention to safety issues when using Kaeser air compressors.
Kobelco air compressor maintenance mode
When servicing is complete the remaining time period must be reset to the default service time.
Notification and warning of 9 Kaeser Control Sigma machine errors
Check the interface link/connection between the two control screens, check the maximum length of the cable and the screen, check that all interface parameters are working properly.
Error messages and warnings 8 sewing Keaser Sigmal control
Check the interface link/connection between the 2 control screens, check the maximum length of the cable and the screen, check all interface parameters are fully active, 1 main frame and 1 sub frame, sub configuration, configuration and character (format) for both are identical
